T-100 Plastisol Primer - available at CDI in Buffalo, NY

Formulated to achieve optimum adhesion under a wide range of application conditions when used in conjunction with Miccro Plastisols.

T-100 is a clear primer adhesive formulated to achieve optimum adhesion under a wide range of application conditions when used in conjunction with Plastisol. In addition to being an excellent general purpose primer, it is especially resistant to hot alkaline solutions.

T-100 has been formulated to comply with the solvent requirements of Rule 66 of the Los Angeles Air Pollution Control District and Regulation 3 of the San Francisco Bay Area Air Pollution Control District.

Characteristics:

  • Color: Clear to Pale Yellow
  • Viscosity: 31 seconds #1 Zahn
  • Coverage Rate: Approximately 380 square feet (35.3 m2) per gallon, 0.3 mil.
  • Weight per Gallon: 7.1 pounds / gallon
  • Flashpoint: 43° F. TCC
  • Solids: 16% by weight
  • T-100 Plastisol Primer is available in: 1, 5, and 55 gallon containers.

Application Procedure:

  1. Clean metal. For best adhesion metal must be physically and chemically clean. Sandblasting with clean sand or pickling and degreasing are satisfactory.
  2. Apply primer by dipping, brushing or spraying. Air dry for 15 minutes and bake at 360° to 400° F for 15 to 45 minutes, depending upon metal mass and oven efficiency.
  3. While metal is hot, dip into the T-100 and leave until the desired coating is formed. The thickness film is determined by the amount of heat in the metal and length of time in the T-100.
  4. Evaporated solvent should be replaced with T-100 primer reducer only.

T100 instruction sheet:

T100 label instructions:

The information supplied above is offered as a service to our customers, and does not relieve the customer from their responsibility to determine the suitability of a particular chemical to their specific purpose. Actual product specifications may vary slightly. Please contact CDI for information prior to purchase.