Miccro XP-410 - available at CDI in Buffalo, NY

Peelable stop-off formulated specifically for electroless nickel, hard coat anodizing and chemical milling. Dip or brush from the shipping container.

Miccro XP-410 is a compound suitable for use in the following cycles:

  • Electroless Nickel Plating
  • Chemical Milling
  • Hard Coat Anodizing
  • Acid Solutions in General

Characteristics:

  • Color: Orange
  • Viscosity: 5000-6000 cps
  • Coverage Rate: Approximately 130 ft2 (12 m2) per gallon
  • Weight per Gallon: 10.96 pounds / gallon
  • Flashpoint: 109 °F TCC
  • Dry Film: 1 mil
  • XP-410 is available in: 1, 5, and 55 gallon containers.

Application Procedure

  1. XP-410 should be stirred prior to usage and periodically if not used for extended periods of time.
  2. Chemically and/or mechanically clean the area of the part to be masked. The area to be masked must be free of all dirt, oil or other contaminants. Cleaning is the most critical aspect of the masking procedure.
  3. Apply XP-410 to the area to be masked by dipping or brushing. For reducing XP-410, use XP-410 Reducer only.
  4. Two or Three coats are recommended depending upon the type of plating/chemical solution and/or length of processing time in solution. Allow at least a one-hour dry time between coats. A longer dry time between coats will improve the performance of the product. This factor is highly dependent on the severity of the plating cycle. Faster drying of XP-410 can be accomplished by force drying for 15 minutes in an oven. Temperatures must not exceed 140 °F and times over 15 minutes. Dry time will vary according to relative humidity. NOTE: Make sure XP-410 has lost all solvent odor before force drying or applying additional coats.
  5. If the area to be masked is highly polished, refer to the “Masking Polished or Smooth Surfaces” technical data page for improved adhesion.
  6. XP-400 can normally be peeled from the part after processing. For mass stripping or removal from recessed areas, use XP-410 REDUCER or MICCROSTRIP A

Miccro XP-400 instruction sheet:

The information supplied above is offered as a service to our customers, and does not relieve the customer from their responsibility to determine the suitability of a particular chemical to their specific purpose. Actual product specifications may vary slightly. Please contact CDI for information prior to purchase.