Distributed by:
Equipment Overview | Filter Pump Industries / Penguin Pump | Process Technology
Digital Combination Controls: DSL Series
| MODEL | VOLTS | MAX AMPS | Repl. Relay | Repl. Trans. | Repl. Sensor | SHIP WT. Lbs./(kg) |
|---|---|---|---|---|---|---|
| C-DSL202 | 240 | 20 | AHD-20-1 | HDD50 2-4/1 | RTD1000 | 16 (7.3) |
| C-DSL204 | 480 | 20 | AHD-20-1 | HDD50 2-4/1 | RTD1000 | 16 (7.3) |
| C-DSL302 | 240 | 30 | AHD-30-1 | HDD50 2-4/1 | RTD1000 | 16 (7.3) |
| C-DSL304 | 480 | 30 | AHD-30-1 | HDD50 2-4/1 | RTD1000 | 16 (7.3) |
| C-DSL502 | 240 | 50 | AHD-50-1 | HDD50 2-4/1 | RTD1000 | 17 (7.7) |
| C-DSL504 | 480 | 50 | AHD-50-1 | HDD50 2-4/1 | RTD1000 | 17 (7.7) |
| C-DSL752 | 240 | 75 | AHD-75-1 | HD100 2-4/1 | RTD1000 | 23 (10.4) |
| C-DSL754 | 480 | 75 | AHD-75-1 | HD100 2-4/1 | RTD1000 | 23 (10.4) |
| C-DSL902 | 240 | 90 | AHD-90-1 | HD100 2-4/1 | RTD1000 | 25 (11.3) |
| C-DSL904 | 480 | 90 | AHD-90-1 | HD100 2-4/1 | RTD1000 | 25 (11.3) |
| C-DSL1202 | 240 | 120 | AHD-120-1 | HD100 2-4/1 | RTD1000 | 27 (12.2) |
| C-DSL1204 | 480 | 120 | AHD-120-1 | HD100 2-4/1 | RTD1000 | 27 (12.2) |
| C-DSL1502 | 240 | 150 | AHD-150-1 | HDD150 2-4/1 | RTD1000 | 33 (15) |
| C-DSL1504 | 480 | 150 | AHD-150-1 | HDD150 2-4/1 | RTD1000 | 33 (15) |
Combination control consists of gasketed plastic enclosure, thermostat, 3 pole contactor and transformer.
Features and Benefits
IMPROVES PROCESS CONTROL:- Easy to read .3” (7.6mm) dual LED displays. Two set points (heating and cooling). Provides precise control for consistent plating.
- Fluoropolymer (FEP) covered 10-foot (3m), 1000-ohm platinum RTD sensor included standard with the control. Provides extended service in corrosive liquids and can be lengthened with ordinary copper hookup wire.
- NEMA 1, IP21, gasketed plastic enclosure with stainless steel hardware.
- cULus.
- Large switching capacities from 20 to 150 amps for up to 600 volts.
- Adjustable temperature range from -328°F (-200°C) to 4208°F (2320°C).
- +/- .25% full span, single digit accuracy.
- 20°F (-7°C) to 140°F (60°C) ambient temperature range.
- Control transformer included.
- Single or three phase.
- Single pull, single throw switch rated at 3 amps for cooling loads.
- Pre-wired P1 terminal blocks.
- Non-volatile memory.
- Programmable high or low temperature alarm output.
- Programmable high set point limit.
- Sensor short and break protection.
- Security code restricted menu.
- Auto tune PID, PID or On/Off control with Auto/Manual operation.
- 25-foot (7.6m) and 50-foot (15.2m) sensors.
- Pre-wired outlets for plug-in heaters (some sizes).
- Ground fault protection of equipment (GFPE) circuitry.
- P2, P3 or P8 thermal protection systems.
- Integrated liquid level control components.
- Front panel mounted digital timers.
- Three wire 100-ohm RTD sensors.
- Type J, K, T, and R thermocouples
- 4-20 mA or 0-10VDC outputs for process recording.
- 4-20 mA or 15VDC control outputs.
- RS485 communication protocol.
- Special sensors (required for temperatures above 500°F [260°C]).
- Scalable voltage and current inputs.
- NEMA 4/4X enclosure (with internal heater for outdoor use).
Downloads: