Distributed by:
Equipment Overview | Filter Pump Industries / Penguin Pump | Process Technology
Digital Thermostats: DSL Series, 1/16 DIN
Features and Benefits
IMPROVES PROCESS CONTROL:- Easy to read dual LED displays (.3 inches high). Two set points (heating and cooling). Provides precise temperature control for consistent plating and etch rates in most aqueous processes.
- Fluoropolymer (FEP) covered 10-foot (3m), 1000-ohm platinum RTD sensor included standard with the control. Provides extended service in corrosive liquids and can be lengthened with ordinary copper hookup wire.
- 1/16 DIN size with NEMA 4X (indoor), IP66, 3R and 12 rated front panel and sealed tactile switches.
- cULus and CE.
- Single pole, single throw switches rated at 3-amps for 120 through 240 volts. Three switches: Set Point 1 (SP1), Set Point 2 (SP2), and alarm output (AL).
- Adjustable temperature range from -328°F (-200°C) to 4208°F (2320°C).
- +/- .25% full span, single digit accuracy.
- 14°F (-10°C) to 131°F (55°C) ambient temperature range.
- Universal power supply: 100 to 240 VAC, 50 to 400 Hz.
- Single phase only.
- Auto tune PID, PID or On/Off control with Auto/Manual operation.
- Non-volatile memory.
- Programmable high and/or low temperature alarm output.
- Programmable high set point limit.
- Sensor short and break protection.
- Security code restricted menu.
CONSULT FACTORY FOR THE FOLLOWING OPTIONS:
- 25-foot (7.6m) and 50-foot (15.2m) sensors.
- Combination controls available for three phase service and larger heater loads.
- Three wire 100-ohm RTD sensors.
- Type J, K, T, and R thermocouples.
- Special sensors required for temperatures above 500°F (260°C).
- Scalable voltage and current inputs.
- 4-20 mA or 0-10VDC outputs for process recording.
- 4-20 mA or 15VDC control outputs.
- Voltage, relay, logic/SSR and current outputs.
- RS232 or RS485 communication protocol.
- Adaptor panels for control retrofits.
- Plastic enclosures for wall mounting.
Downloads: